Picdem failed to program flash

So it was not able to detect. Hi bkushalhal5 As you can see in your log file the programmer is not able to find any valid target in your JTAG chain. On my system I am using a Linux machine , there is only a single instance that is running. HI ibaie , That issue is solved, It was the hardware problem, Now the device gets connected. However, it still fails to program the flash. If flash programming fails, configure device for JTAG boot mode and try again. We recommend to use JTAG boot mode when programming the flash.

I have created the new projec and edited the main. Hi there! Connect and share knowledge within a single location that is structured and easy to search. I followed the documentation on the Diolan's web site. I did not encrypt my application using the encoder, I just tried to write it to memory without encrypt it. So, I copied and paste my. I opened the console and typed:.

It always inform: "USB device not recognized". Good observation, I saw at the datasheet that minimum value of CUSB is nF and there is no maximum and typical values. The Windowa 10 stopped to inform that the device was not connected, but at the device manager it is still with a yellow exclamation But this time in HID USB.

The error mentioned before still happens. In source files where was originally include "P18F On the Header files, I remove "P18F INC" and put "P18F INC instead that I downloaded from here.

The others I left default. And this configuration works when I run my application without the bootloader. But, when I will compiled the bootloader, I did not configure the configuration bits, the checkbox "Configuration Bits set in code" is selected as is said in the documents. Sign up to join this community.

Close Menu. Welcome to EDAboard. To participate you need to register. Registration is free. Click here to register now. Register Log in. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser. Thread starter jbrathod88 Start date Jul 25, Status Not open for further replies.

The programmer is supposed to support these two controllers and I follows every steps which are written in its user manual. But till I cannot program any of F or F controller. Please help me out of this. Seek for the solution of this. Thanking you all. Click to expand There are several 'unofficial' software upgrades to the K which do support the 18F Do a search for "DIYPack25ep" or "micropro26" to see if you can find them.